2010-2013 Mazda Speed 3 Front Splitter V2
- Designed for 2010-2013 MAZDA SPEED 3
- - Made from Aerospace Lightweight ALUMINUM no ABS PLASTIC!!!!
- - Made in the USA
- - Comes fully CNC'd and professionally powder coated gloss black.
- - Comes pre-drilled
- - Fitment Guaranteed
- - Hardware are included
- - Professional install highly recommended
What's the purpose of having a front splitter?
An automotive splitter is a modification typically found at the front of the car, containing a protruding flat surface acting as a firm extension of the front bumper. There are many different configurations as far as their aesthetic, and utilized material. The design and purpose is aimed at decreasing front end lift, which would equate to numerous performance benefits. When a car reaches higher speeds, it will accumulate air pressure build up at the front of the vehicle. All of this air will end up going both above the car, as well as below the car (under the front bumper). When excess amounts of this air builds up, the under-car air pressures builds up. This increased air pressure contributes to lift, which causes the front end of the vehicle to lift up. This results in decreased traction on the road & a compromised handling characteristic. The key to alleviate this, is creating positive downforce. The splitter forces the high pressure air upwards where it builds up around the bumper, and ultimately migrates this pressure over the car resulting in reduced lift. The splitter is typically supported by rods to ensure that the splitter stays parallel to the ground, rods will also assist with the outside forces and elements endangering the integrity of the splitter.
The best item ever love it fits my mazda 3 perfect thanks guys ❤️
Looks so good!
Every thing went so smooth, from order to install!
Lack of Install Info
Aeroflow was very helpful when it came to shipping info and questions I had. I love the product(s) as they are beautiful. However I've been unable to install the front splitter because there isn't Mazda specific install instructions. I tried with the bumper off the car and it looked great in my garage but I was unable to put the bumper back on the vehicle because I installed it wrong. Or so I suppose. I'll try again someday, for now it looks good by itself in my garage.
2013 mazdaspeed 3 splitter
the quality of the item is great! had to email to find out that drilling into the bumper was required for install. after that the install was pretty straight forward. you will need two people to make the two first outside holes though as the bumper ends will need to be stretched out some to fit the splitter! (no worries though it fits back on the car fine and looks great.) after the first two holes are made and bolts are installed it is just a matter of more drilling (and cutting if you want the factory pcs in the front to go back in.) install is 4 hours total. i tested it up to 120 mph on the track and no issues it mounts really strong to the bumper and doesn't flex much at all. if you are lowered be carefully around speed bumps and parking curbs. i am lowered 2" have no issues with speed bumps in shopping centers but the parking curbs are to high and you will hit them if you pull up to far!